How Do I Make A Toggle Necklace?

Looking for a simple beading project to get you warmed up? Try making a simple toggle necklace.

A toggle necklace is a beaded necklace that has the toggle in the front of the piece as a dramatic focal point. Follow these easy step by step instructions to make a beautiful glass beaded toggle necklace.

MATERIALS NEEDED:

Glass Beads
bead stringing wire
toggle clasp set
crimp beads
head pins or eye pins
jump rings
needle-nose pliers
wire cutters

INSTRUCTIONS:

1.  Start with a length of bead stringing wire that is approximately six inches longer than the piece of jewelry you intend to make. 

2.  Slide on a crimp bead, then the loop end of the toggle.

3.  Bend approximately two inches of the wire, going back through the crimp bead, and draw it snug against the clasp.

4.  Use your needle-nose pliers to flatten the crimp bead against the clasp so that it cannot slide up or down.

5.  String all of the beads onto the wire (the first few beads should be strung over both thicknesses of wire).

6.  Slide the second crimp bead onto the wire, then the other half of the clasp, then go back through the crimp bead and several other beads.

7.  Pull the wire until all of the beads are snug against each other. 

8.  Then, flatten the crimp bead. 

9.  Use a pair of wire cutters to cut off the remaining wire as close to the beads as possible.

Article Source: http://www.beadpatternsonline.com/.